## PLEASE READ THIS GUIDE BEFORE YOU START PRINTING ANYTHING
There are 2 variations of this mounting assembly which will be referred to as version A and version B throughout this guide. We recommend using version A unless you are having trouble with the dovetail joints (the parts that slide tightly together).
holder3.STL should be printed face down as below. Be sure to **use** support material as this will certainly fail without. This part will most likely be very difficult to remove from the bed of the printer due to its high surface area.
t-top.STL should be printed in the following orientation. It will produce 1 usable part but actually has 3 separate parts as far as CURA (or any other STL viewer/slicer) is concerned. 2 of them are intended to act as specially made support for the primary part. Normal support material **must** also be used.
The reason this version is included here is in case there are problems with the fit of version A's dovetail joints due to using different filaments or different printers. Instead of requiring tight tollerence plastic-plastic connections, this version instead relies on four bolts to clamp onto the scooter's vertical tube.
holder.STL should be made exactly as in version A.
arm.STL should be printed in the following orientation to minimize the risk of layer delamination causing catastrauphic failure in the clamping system. Also, be sure to **use** support material or the print will be likely to fail.