add some first images

README.md

@@ -1 +1,29 @@
 # Coaxpress High Speed Camera
+
+## Getting Started
+
+First issue was installing the framegrabber in a PCIEx4 slot. It seemed to work but was complaining about not having x8 so I moved it.
+I'm not sure if cable order matters for the coax connections but I found an order that does and I'm sticking to it.
+
+From here on I'm using the firmware pre-installed on the framegrabber and camera. The framegrabber indicates it needs a firmware update and I'll get to that at some point.
+```
+21:14:02.172 [WARNING] Device open with warnings: W: Firmware update required
+```
+This is the what the framegrabber reports for firmware:
+![1731817045545](image/README/1731817045545.png)
+
+And for the camera:
+![1731817117549](image/README/1731817117549.png)
+
+It looks like order of operations is very important in Vision Point. This camera comes up as 1608x400 pixels at 500fps:
+![1731817401898](image/README/1731817401898.png)
+
+If I stream data and then decrease the resolution to increase frame rate, the preview goes crazy and I just get a bunch of garbage:
+![1731817483859](image/README/1731817483859.png)
+This looks to me like desyncronization of the camera and framegrabber.
+
+Similarly increasing resolution after streaming data causes mayhem as well:
+![1731817591941](image/README/1731817591941.png)
+
+If I instead change the resolution to 640x200 (which based on the label I think should give me 8000fps) as the very first thing after connecting, then I do see an increase in frame rate to 1000fps. This isn't the 8000 I expect but indicates that this is the right way to do this.
+